In-floor radiant heat, zoned room by room.
Warm floors and quiet, even heat for new builds, additions, basements, garages and shops across Simcoe County and Muskoka.
Why in-floor
Radiant floor heat warms the slab or subfloor and lets it warm the room from the ground up. No blowing air, no cold spots under the windows, no furnace cycling on and off. Each room or zone gets its own thermostat, so the bathroom can run warmer than the bedroom and the garage can sit at 10 degrees until you need it.
It is the right choice for slab-on-grade builds, basements getting a new floor, garages and workshops, and any house where the owners are done with cold floors in February.
What we install
In-slab PEX
Oxygen-barrier PEX tied to the mesh or clipped to insulation before the pour, in loops sized to the heat loss.
Staple-up & joist-bay
Under existing subfloors with heat-transfer plates, for renovations where the floor stays.
Overpour & panel systems
Thin-slab and routed panel systems where height is limited.
Manifolds & zoning
A manifold per floor with flow meters, actuators and a thermostat per zone.
Mixing & controls
Mixing valves, outdoor reset and floor sensors so the slab never runs hotter than the floor finish allows.
Boiler supply
Condensing boilers sized to the full load, with domestic hot water off the same plant where it makes sense.
How we do it
Where in-floor fits
Hydronic in-floor heating
Costs depend on zones, floor construction and whether a boiler is included. Any rebate you qualify for is built into the written quote. See the full cost guide →
“Peter is very good person and reliable whom you can trust on his work and on time.”
— Bipin M. (combination boiler service), Google review
Questions we get asked
Before the slab is poured. Tubing goes into the concrete or under the subfloor, so the decision belongs at the drawing stage.
Yes, as a retrofit under or over the floor. It costs more per square foot than a new slab, and a heated garage slab is often the best-value project.
Radiant floors heat only. Most custom builds pair them with a ducted heat pump or air handler for cooling and ventilation.
NTI, Viessmann and Navien condensing boilers, sized to the zones and domestic hot water.
We do, as one team: layout, zoning, manifolds, boiler and controls, priced before anything is ordered and installed by the people who drew it.
Finishing a basement or pouring a slab?
The best time to plan radiant is before the floor goes in. Send us the drawings and we’ll come back with a layout and a fixed price.